Research & Development
All our products are the result of our own research and development. Most of our customers turn to us in the situations where conventional solutions do not exist or stop working satisfactorily. At first, we analyse each new problem together with the customer.
If we can see a possible way to solve the problem, we proceed to the elaboration of the feasibility study, on the basis of which we reach the detailed understanding of this problem. Only when we are sure that we can fulfil the customer’s needs, we approach to the development of a technical solution.
Before the final deployment of the product in the production process, together with the customer, we will test the product in the operation, during which we will reveal any deviations from the specified requirements. After the end of the testing operation, the device is handed over to the customer and the process of its development is completed. In addition to the industrial development, we also participate in the preparation and solution of the national or international scientific projects.
An individual approach to customer needs requires original solutions.
Tension in the Conveyor Belt, Analysis of Ratios during Start-Up
A comprehensive project focused on the measurements, simulations and analysis on the selected section of the belt transport in the start-up mode for the evaluation of the existing state of the start-up and proposals to solve the situation with the goal to minimize the risk of the breaking of the belt during the start-up phase.
From the cybernetical point of view, the conveyor belt is a complex system, it has its own dynamic properties, to which the control loop needs to be adapted. The critical operational modes of the conveyor belt are the starting and stopping phases. In these modes, a significant amount of energy is accumulated and released into and out of the elastic deformations of the conveyor belt. The induced mechanical stresses can cause the belt oscillations in the longitudinal direction, which can lead to the resonance and, in the worst case, to the mechanical damage of the conveyor line. In order to prevent these undesirable conditions, we participated in the analysis of the mechanical stress ratios in the conveyor belt.
Marking of Conveyor Belts
The conveyor belt marking system, in abbreviation ZDP. The prototype of the ZDP system was sequentially verified, adjusted and optimized as a part of the testing operation on the selected conveyors, which lead to the verification of the method of the code marks’ implementation.
Increasing of the operation time without a failure is the goal of every maintenance department. Glued joints are one of the critical points of the conveyor belts. The belt vulcanization is often performed under demanding conditions that affect the quality of the joint. The resulting joint represents a critical point of the conveyor belt, which creates the need to distinguish, mark and subsequently monitor these points. For the marking needs in the difficult operating conditions, we have developed in cooperation with our partners the conveyor belt marking system using the magnetism.